Cameras and routers should be put on a UPS system to prevent in case of power loss.
Be prepared to waterproof your connectors using rubber electrical compound and/or splicing tape.
Appropriate power +
All HauteSpot routers operate on 11-27VDC. Be sure camera enclosures have heat blowers operating at 24VAC.
Ethernet switch device +
The HauteWRAP family offers a 3 port Ethernet switch model. This eliminates the need for a switch device.
Antenna beamwidth +
The narrower the horizontal beamwidth, the higher the gain; narrow beam antennas receive less noise.
The lower the frequency, the more prone to interference your network will be.
The fewer useable channels you have available, the more difficult to determine the source of interference.
Antenna for mobile +
Use a multi-polarized or circular polarity antenna on the remote vehicle, a standard sector antenna on the master/AP.
I just wanted to take a moment and say a big thank you for the extremely professional team at CVREPS and Hautespot.
I have had two large jobs recently that your team helped out on. I need you to understand that every time I called and needed assistance you guys were all over it, from design, to questions and follow up. I work with a lot of vendors and I can go to any of them for a solution but I have NEVER been disappointed in your team. Even if one of them is not available, that person will ensure I have someone to take care of the issue. So even thought I probably bore them with my gratitude, I wanted to send you a thank you for such a fabulous team.