HauteSpot FAQs
How do I factory reset my HR-WINDi to a default factory settings?
- Date added:
- Wednesday, 13 January 2010
- Last revised:
- Friday, 22 January 2010
- Hits:
- 3914
- Rating:
- Vote for this:
-
- 
- favoured:
-
0
Answer
On the back of the WINDi unit in the bottom left hand corner there is a reset button. If you press and hold the button for two seconds the device wil reboot, if you press and hold the reset button for 5 to 7 seconds, the unit will reset to its factory default state.
Vidovation demos portable wireless network video recorder. The microNVR is ideal for many applications combining on-site edge recording with live wireless relay such as in-vehicle video monitoring, light pole mounted video monitoring, solar powered remote video monitoring stations, camera back video recording and relay, and a pocket-carried video recorder.
We put the HauteSpot microNVR and Global Emergency Resources eWRAP to the test. Driving 700 miles from Meridian, Mississippi to Augusta, Georgia, we put a Mobotix megapixel camera attached to a microNVR and eWRAP in a moving van. The microNVR recorded at full frame rate and resolution all of the video from the camera. It also transcoded and pushed video out over the eWRAP using 3G EvDO wireless. The push architecture remained connected throughout the entire trip including through some relatively remote areas. See as short captured video of this test. 70 miles an hour, 700 miles, 10fps, VGA…